Removing The Transportation Packing Member Of The Process Unit --9-20 - Canon imagePRESS 1135 Series Service Manual

Removing the transportation packing member of the process unit
1) Remove the ITB positioning plate.
• 2 screws (The removed stepped screw will be used in "Removing the transportation packing
member of the ITB unit" step 7).)
x2
CAUTION :
Do not touch the charging wire when removing the primary charging assembly.
9
Installation > Installation > Removing the transportation packing member of the process unit
2) Lift the primary charging cleaning motor unit to remove the primary charging assembly.
F-9-42
3) Remove the drum rotation-prevention member and the drum home position detection flag.
(The removed the drum rotation-prevention member will not be used anymore. The drum rotation-
prevention member, stepped screw, and spring will be used in step 18).)
• 1 stepped screw
• 1 spring
F-9-44
9 Installation > Installation > Removing the transportation packing member of the process unit
x1
9-20
F-9-43
F-9-45
9-20