Canon imagePRESS 1135 Series Service Manual page 1507

■ Removing Deck Upper Front/Middle Inner/Lower Inner Covers
1) Remove the deck upper front cover [1].
• 2 Screws [2]
2) Remove the deck middle inner cover [3].
• 3 Screws [4]
3) Remove the deck lower inner cover [5].
• 3 Screws [6]
CAUTION:
Depending on the locations to install the cassette heater unit, remove either of deck
upper front/middle inner/lower inner covers.
[4]
[6]
9
Installation > Cassete Heater-32 > Installation Procedure (Connecting to POD Deck / Secondary POD Deck) > Installing Cassette Heater Unit
[2] [1]
[3]
[4]
[5]
F-9-190
9 Installation > Cassete Heater-32 > Installation Procedure (Connecting to POD Deck / Secondary POD Deck) > Installing Cassette Heater Unit
■ Installing Cassette Heater Unit
1) Remove the heater mount [1] inside of the upper deck to the forward. (The removed Screw
will be used in step 6).)
• 1 Connector [2]
• 2 Screws [3]
CAUTION:
The steps below describe how to install the cassette heater unit to the inside of POD
deck (Upper deck). The same steps are applicable to cassette heater unit installation in
POD deck (middle, lower deck) /secondary POD deck (upper, middle, lower deck) and
thus skipped here.
[2]
x1
x2
9-90
[3]
[1]
9-90