Canon imagePRESS 1135 Series Service Manual page 1376

SORTER> ADJUST
ST1-ALR2 Stckr left tray rear align plate: stk
Lv.1 Details To adjust the position of rear alignment plate of the left tray on the
stack unit of the stacker.
As the value is increased by 1, the rear alignment plate moves by
0.16 mm.
+: toward front (narrow)
-: toward rear (widen)
Use case Restore the position to the factory setting when EEPROM/master
controller PCB is replaced
Adj/set/operate method Enter the setting value and press OK key.
Display/adj/set range -32 to 32
Unit 0.16 mm
Default value 0
ST1-ALF1 Stckr right tray front align plate: stk
Lv.1 Details To adjust the position of front alignment plate of the right tray on the
stack unit of the stacker.
As the value is increased by 1, the rear alignment plate moves by
0.16 mm.
+: toward front (narrow)
-: toward rear (widen)
Use case Restore the position to the factory setting when EEPROM/master
controller PCB is replaced
Adj/set/operate method Enter the setting value and press OK key.
Display/adj/set range -32 to 32
Unit 0.16 mm
Default value 0
ST1-ALF2 Stckr left tray front align plate: stk
Lv.1 Details To adjust the position of front alignment plate of the left tray on the
stack unit of the stacker.
As the value is increased by 1, the rear alignment plate moves by
0.16 mm.
+: toward front (narrow)
-: toward rear (widen)
Use case Restore the position to the factory setting when EEPROM/master
controller PCB is replaced.
Adj/set/operate method Enter the setting value and press OK key
Display/adj/set range -32 to 32
Unit 0.16 mm
Default value 0
8
Service Mode > SORTER > ADJUST
8 Service Mode > SORTER > ADJUST
SORTER> ADJUST
ST1-ALT1 Right tray push-on pstn in feed way: stk
Lv.1 Details To adjust the push-on position in feed direction of right tray on the
stack unit of stacker.
As the value is increased by 1, the push-on position moves by
0.15 mm.
+: toward front (narrow)
-: toward rear (widen)
Use case Restore the position to the factory setting when EEPROM/master
controller PCB is replaced
Adj/set/operate method Enter the setting value and press OK key.
Display/adj/set range -34 to 34
Unit 0.15 mm
Default value 0
ST1-PULL Lead-in belt up/down motor pstn adj: stk
Lv.1 Details To adjust the position of up/down motor of lead-in belt at the feed
direction side on the stacker unit on the stacker.
As the value is increased, lead-in force is reduced.
Use case Restore the position to the factory setting when EEPROM/master
controller PCB is replaced.
Adj/set/operate method Enter the setting value and press OK key.
Display/adj/set range 0 to 4
Default value 0
ST1-ALT2 Left tray push-on pstn in feed way: stk
Lv.1 Details To adjust the push-on position in feed direction of left tray on the
stack unit of stacker.
As the value is increased by 1, the push-on position moves by
0.15 mm.
+: toward front (narrow)
-: toward rear (widen)
Use case Restore the position to the factory setting when EEPROM/master
controller PCB is replaced
Adj/set/operate method Enter the setting value and press OK key.
Display/adj/set range -34 to 34
Unit 0.15 mm
Default value 0
8-433
8-433