Canon imagePRESS 1135 Series Service Manual page 1238

COPIER > OPTION > USER
DK6-ASST Air heater setting of POD2 mddle deck
Lv.1 Details Set the condition (media/environment) to turn on the paper
separation air heater at the tandem POD middle deck.
When the media is switched from non-coated paper to coated paper,
paper pickup operation does not start until the temperature of the
paper separation air heater reaches the specified temperature.
To shorten the wait time, make a setting of "Not dependent on the
media".
When the use environment is near the threshold for turning ON/
OFF the heater, switching occurs frequently, which increases the
wait time. To shorten the wait time, make a setting of turning on the
heater constantly.
Use case When it is requested to shorten the wait time
Adj/set/operate method 1) Enter the setting value and press the OK key.
2) Turn OFF/ON the main power.
Caution • To make a setting of "Not dependent on the media", be sure to
receive approval from the user in advance after explaining that
there is a possibility that transfer performance for non-coated
paper may decrease.
• To make a setting of turning on the heater constantly, be sure to
receive approval from the user in advance after explaining that
there is a possibility that transfer performance may decrease when
humidity decreases.
Display/adj/set range 0 to 2
0: Dependent on the media and environment condition
1: Dependent on the environment condition (Not dependent on the
media)
2: Turning on the heater constantly (Not dependent on environment/
media)
Default value 0
Related service mode COPIER> OPTION> USER> DK1-ASST to DK5-ASST, DK7-ASST
to DK10ASST
8
Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > USER
8 Service Mode > COPIER > OPTION (Mechanical specifications Setting Mode) > USER
COPIER > OPTION > USER
DK7-ASST Air heater setting of POD2 lower deck
Lv.1 Details Set the condition (media/environment) to turn on the paper
separation air heater at the tandem POD lower deck.
When the media is switched from non-coated paper to coated paper,
paper pickup operation does not start until the temperature of the
paper separation air heater reaches the specified temperature.
To shorten the wait time, make a setting of "Not dependent on the
media".
When the use environment is near the threshold for turning ON/
OFF the heater, switching occurs frequently, which increases the
wait time. To shorten the wait time, make a setting of turning on the
heater constantly.
Use case When it is requested to shorten the wait time
Adj/set/operate method 1) Enter the setting value and press the OK key.
2) Turn OFF/ON the main power.
Caution • To make a setting of "Not dependent on the media", be sure to
receive approval from the user in advance after explaining that
there is a possibility that transfer performance for non-coated
paper may decrease.
• To make a setting of turning on the heater constantly, be sure to
receive approval from the user in advance after explaining that
there is a possibility that transfer performance may decrease when
humidity decreases.
Display/adj/set range 0 to 2
0: Dependent on the media and environment condition
1: Dependent on the environment condition (Not dependent on the
media)
2: Turning on the heater constantly (Not dependent on environment/
media)
Default value 0
Related service mode COPIER> OPTION> USER> DK1-ASST to DK6-ASST, DK8-ASST
to DK10ASST
8-295
8-295