18) Fit the protrusion of the drum home position detection flag into the groove of the drum shaft.
• 1 spring (use the spring removed in step 3) at "Removing the transportation packing member of the process unit".)
• 1 stepped screw (use the stepped screw removed in step 3) at "Removing the transportation packing member of the process unit".)
CAUTION :
• When tightening the screw, be sure to hold the
drum home position detection flag and fix it.
• If the screw is not securely tightened, uneven
pitch may occur.
• Turning the drum clockwise may damage the
surface of the drum.
NOTE :
After tightening the Stepped Screw, check that the thickness of the spring is 15 mm.
9
Installation > Installation > Installing the developing assembly
F-9-66
9
Installation > Installation > Installing the developing assembly
9-30
F-9-65
9-30