Commands; Beeper.beep(); Beeper.enable - Keithley 2651A Reference Manual

Section 7: Command reference

Commands

beeper.beep()

This function generates an audible tone.
Type TSP-Link accessible
Function Yes
Usage
beeper.beep(duration, frequency)
duration
frequency
Details
The beeper will not sound if it is disabled. It can be disabled or enabled with the beeper.enable attribute, or
through the front-panel Main Menu.
Example
beeper.enable = beeper.ON
beeper.beep(2, 2400)
Also see

beeper.enable

beeper.enable
This attribute allows you to turn the beeper on or off.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
state = beeper.enable
beeper.enable = state
state
Details
Disabling the beeper also disables front-panel key clicks.
7-8
Model 2651A High Power System SourceMeter® Instrument Reference Manual
Affected by
The amount of time to play the tone in seconds; the allowable range is 0.1 s to 100 s
The frequency of the tone in Hertz (Hz)
(on page 7-8)
Affected by
Recall
Disable the beeper (beeper.OFF or 0)
Enable the beeper (beeper.ON or 1)
Where saved Default value
Enables the beeper and generates a
two-second, 2400 Hz tone.
Where saved Default value
Saved setups beeper.ON
2651A-901-01 Rev. A / March 2011