Localnode.model; Localnode.password - Keithley 2651A Reference Manual

Section 7: Command reference
Details
To achieve optimum noise rejection when performing measurements at integer NPLC apertures, set the line
frequency attribute to match the frequency (50 Hz or 60 Hz) of the AC power line.
When using this command from a remote node, localnode should be replaced with the node reference, for
example node[5].linefreq.
When this attribute is set, the localnode.autolinefreq attribute is automatically set to false. You can
have the instrument automatically detect the AC power line frequency and set this attribute with the line
frequency detected when the instrument power is turned on by setting the localnode.autolinefreq attribute
to true.
Example 1
frequency = localnode.linefreq
Example 2
localnode.linefreq = 60
Also see
localnode.autolinefreq

localnode.model

This attribute stores the model number.
Type TSP-Link accessible
Attribute (R) Yes
Usage
model = localnode.model
model
Example
print(localnode.model)
Also see
localnode.description
localnode.revision
localnode.serialno

localnode.password

This attribute stores the remote access password.
Type TSP-Link accessible
Attribute (W) Yes
7-134
Model 2651A High Power System SourceMeter® Instrument Reference Manual
(on page 7-132)
Affected by
Not applicable
The model number of the instrument
(on page 7-133)
(on page 7-138)
(on page 7-138)
Affected by
LAN reset
LAN restore defaults
Reads line frequency setting.
Sets the line frequency to 60 Hz.
Where saved
Not applicable
Outputs the model number.
Where saved
Nonvolatile memory
Default value
Not applicable
Default value
""
2651A-901-01 Rev. A / March 2011