Lan.autoconnect; Lan.config.dns.address[N] - Keithley 2651A Reference Manual

Section 7: Command reference
Details
Disconnects all existing LAN connections to the instrument and re-initializes the LAN with the current
configuration settings.
This function initiates a background operation. LAN configuration could be a lengthy operation. Although the
function returns immediately, the LAN initialization will continue to run in the background.
Even though the LAN configuration settings may not have changed since the LAN was last connected, new
settings may take effect due to the dynamic nature of DHCP or DLLA configuration.
Re-initialization takes effect even if the configuration has not changed since the last time the instrument
connected to the LAN.
Example
lan.applysettings()
Also see
None

lan.autoconnect

This attribute is used to enable or disable link monitoring.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
state = lan.autoconnect
lan.autoconnect = state
state
Details
This attribute sets the LAN link monitoring and automatic connection state.
When this is set to lan.ENABLE, all connections are closed if the link to the LAN is lost for more than the time
specified by lan.linktimeout.
Set this attribute to lan.ENABLE to automatically reset the LAN configuration after the LAN link is established.
Also see
lan.linktimeout
lan.restoredefaults()

lan.config.dns.address[N]

Configures DNS server IP addresses.
Type TSP-Link accessible
Attribute (RW) Yes
7-104
Model 2651A High Power System SourceMeter® Instrument Reference Manual
Affected by
LAN restore defaults
LAN link monitoring state:
1 or lan.ENABLE: Enables automatic link reconnection and monitoring
0 or lan.DISABLE: Disables automatic link reconnection and monitoring
(on page 7-112)
(on page 7-114)
Affected by
LAN restore defaults
Re-initialize the LAN interface with new settings.
Where saved Default value
Nonvolatile memory lan.ENABLE
Where saved Default value
Nonvolatile memory "0.0.0.0"
2651A-901-01 Rev. A / March 2011