Status.operation.instrument.trigger_Blender - Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual

status.operation.instrument.trigger_blender.*

This attribute contains the operation status trigger blender summary register set.
Type TSP-Link accessible
Attribute - -
.condition (R) Yes
.enable (RW) Yes
.event (R) Yes
.ntr (RW) Yes
.ptr (RW) Yes
Usage
operationRegister = status.operation.instrument.trigger_blender.condition
operationRegister = status.operation.instrument.trigger_blender.enable
operationRegister = status.operation.instrument.trigger_blender.event
operationRegister = status.operation.instrument.trigger_blender.ntr
operationRegister = status.operation.instrument.trigger_blender.ptr
status.operation.instrument.trigger_blender.enable = operationRegister
status.operation.instrument.trigger_blender.ntr = operationRegister
status.operation.instrument.trigger_blender.ptr = operationRegister
operationRegister
Details
These attributes are used to read or write to the operation status trigger blender summary registers. Reading a
status register returns a value. The binary equivalent of the returned value indicates which register bits are set.
The least significant bit of the binary number is Bit B0, and the most significant bit is Bit B15.
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to
2) and Enable and transition registers
meanings:
Bit Value
B0-B9 Not used
B10
status.operation.instrument.trigger_blender.TRIGGER_OVERRUN
status.operation.instrument.trigger_blender.TRGOVR
B11- Not used
B15
2651A-901-01 Rev. A / March 2011
Affected by
- -
Not applicable
Status reset
Status reset
Status reset
Status reset
The operation status trigger blender summary register's status. A zero (0) indicates
no bits set (also send 0 to clear all bits); the only valid value other than 0 is 1024
(on page E-18). The individual bits of this register have the following
Where saved Default value
- - - -
Not saved Not applicable
Not saved 0
Not saved 0
Not saved 0
Not saved 1024 (All bits set)
Status register sets
Section 7: Command reference
(on page E-
Description
Not applicable.
Set bit indicates one
or more enabled bits
for operation status
trigger blender
overrun register is
set.
Bit B10 decimal
value: 1024
Binary value:
0100 0000 0000
Not applicable.
7-283