Tsplink.writebit(); Tsplink.writeport() - Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual
Also see
tsplink.trigger[N].clear()

tsplink.writebit()

This function sets a TSP-Link synchronization line high or low.
Type TSP-Link accessible
Function Yes
Usage
tsplink.writebit(bit, data)
bit
data
Details
Use tsplink.writebit() and tsplink.writeport() to control the output state of the synchronization
line when trigger operation is set to tsplink.TRIG_BYPASS.
If the output line is write-protected by the tsplink.writeprotect attribute, this command is ignored.
The reset function does not affect the present states of the digital I/O lines.
Example
tsplink.writebit(3, 0)
Also see
tsplink.readbit()
tsplink.readport()

tsplink.writeport()

tsplink.writeprotect
tsplink.writeport()
This function writes to all TSP-Link synchronization lines.
Type TSP-Link accessible
Function Yes
Usage
tsplink.writeport(data)
data
2651A-901-01 Rev. A / March 2011
(on page 7-351)
Affected by
The trigger line (1 to 3)
The value to write to the bit:
•
Low: 0
• High: 1
(on page 7-348)
(on page 7-349)
(on page 7-359)
(on page 7-360)
Affected by
Value to write to the port (0 to 7)
Where saved Default value
Sets synchronization Line 3 low (0).
Where saved Default value
Section 7: Command reference
7-359