Status.operation.instrument.tsplink.trigger_Overrun - Keithley 2651A Reference Manual

Section 7: Command reference
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to
2) and Enable and transition registers
meanings:
Bit Value
B0-B9 Not used
B10

status.operation.instrument.tsplink.TRIGGER_OVERRUN

status.operation.instrument.tsplink.TRGOVR
B11- Not used
B15
In addition to the above constants, operationRegister can be set to the numeric equivalent of the bit to set.
For example, to set bit B10, set operationRegister to 1024.
Example
status.operation.instrument.tsplink.enable = 1024
Also see
Operation Status Registers
status.operation.instrument.tsplink.trigger_overrun.*
status.operation.instrument.tsplink.trigger_overrun.*
This attribute contains the operation status TSP-Link overrun register set.
Type TSP-Link accessible
Attribute - -
.condition (R) Yes
.enable (RW) Yes
.event (R) Yes
.ntr (RW) Yes
.ptr (RW) Yes
7-290
Model 2651A High Power System SourceMeter® Instrument Reference Manual
(on page E-18). The individual bits of this register have the following
(on page E-20)
(on page 7-290)
Affected by
- -
Not applicable
Status reset
Status reset
Status reset
Status reset
Status register sets
Sets the trigger overrun bit of
the operation status TSP-Link
summary enable register
using a decimal value.
Where saved Default value
- - - -
Not saved Not applicable
Not saved 0
Not saved 0
Not saved 0
Not saved 14 (All bits set)
2651A-901-01 Rev. A / March 2011
(on page E-
Description
Not applicable
Set bit indicates one or
more enabled bits for the
operation status TSP-
Link overrun register is
set.
Bit B10 decimal value:
1024
Binary value:
0100 0000 0000
Not applicable