Tsplink.trigger[N].Stimulus - Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual

tsplink.trigger[N].stimulus

This attribute specifies the event that causes the synchronization line to assert a trigger.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
eventID = tsplink.trigger[N].stimulus
tsplink.trigger[N].stimulus = eventID
eventID
N
Details
To disable automatic trigger assertion on the synchronization line, set this attribute to 0.
Do not use this attribute when triggering under script control. Use tsplink.trigger[N].assert() instead.
The eventID parameter may be one of the existing trigger event IDs shown in the following table.
Trigger event IDs*
Event ID
smuX.trigger.SWEEPING_EVENT_ID
smuX.trigger.ARMED_EVENT_ID
smuX.trigger.SOURCE_COMPLETE_EVENT_ID
smuX.trigger.MEASURE_COMPLETE_EVENT_ID
smuX.trigger.PULSE_COMPLETE_EVENT_ID
smuX.trigger.SWEEP_COMPLETE_EVENT_ID
smuX.trigger.IDLE_EVENT_ID
digio.trigger[N].EVENT_ID
tsplink.trigger[N].EVENT_ID
lan.trigger[N].EVENT_ID
display.trigger.EVENT_ID
2651A-901-01 Rev. A / March 2011
Affected by
Instrument reset
TSP-Link trigger N reset
The event identifier for the triggering event
The trigger line (1 to 3)
Where saved Default value
Not saved 0
Event description
Occurs when the SMU transitions from the idle state
to the arm layer of the trigger model
Occurs when the SMU moves from the arm layer to
the trigger layer of the trigger model
Occurs when the SMU completes a source action
Occurs when the SMU completes a measure action
Occurs when the SMU completes a pulse
Occurs when the SMU completes a sweep
Occurs when the SMU returns to the idle state
Occurs when an edge is detected on a digital I/O line
Occurs when an edge is detected on a TSP-Link line
Occurs when the appropriate LXI trigger packet is
received on LAN trigger object N
Occurs when the TRIG key on the front panel is
pressed.
Section 7: Command reference
7-357