Serial.databits; Serial.flowcontrol - Keithley 2651A Reference Manual

Section 7: Command reference
Also see
RS-232 interface operation

serial.databits

serial.flowcontrol

serial.parity (on page 7-165)
serial.databits
This attribute configures character width (data bits) for the RS-232 port.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
bits = serial.databits
serial.databits = bits
bits
Details
A new data width setting takes effect when the command to change it is processed.
Allow ample time for the command to be processed before attempting to communicate with the
instrument again. If possible, set the character width from one of the other command interfaces or
from the front panel.
The reset function has no effect on data bits.
Example
serial.databits = 8
Also see
RS-232 interface operation
serial.baud (on page 7-163)
serial.flowcontrol
serial.parity (on page 7-165)
serial.flowcontrol
This attribute configures flow control for the RS-232 port.
Type TSP-Link accessible
Attribute (RW) Yes
7-164
Model 2651A High Power System SourceMeter® Instrument Reference Manual
(on page 2-81)
(on page 7-164)
(on page 7-164)
Affected by
Not applicable
An integer representing the character width (7 or 8)
(on page 2-81)
(on page 7-164)
Affected by
Not applicable
Where saved
Nonvolatile memory
NOTE
Sets data width to 8.
Where saved
Nonvolatile memory
Default value
8
Default value
serial.FLOW_NONE
2651A-901-01 Rev. A / March 2011