Tsplink.trigger[N].Overrun - Keithley 2651A Reference Manual

Section 7: Command reference
Also see
digio.writebit()
digio.writeport()
tsplink.trigger[N].assert()
tsplink.trigger[N].clear()

tsplink.trigger[N].overrun

tsplink.trigger[N].release()
tsplink.trigger[N].reset()
tsplink.trigger[N].stimulus
tsplink.trigger[N].wait()
tsplink.trigger[N].overrun
This attribute indicates if the event detector ignored an event while in the detected state.
Type TSP-Link accessible
Attribute (R) Yes
Usage
overrun = tsplink.trigger[N].overrun
overrun
N
Details
Indicates that an event was ignored because the event detector was in the detected state when the event was
detected.
Indicates the overrun state of the event detector built into the line itself.
It does not indicate whether an overrun occurred in any other part of the trigger model or in any other detector
that is monitoring the event.
It does not indicate output trigger overrun.
Example
print(tsplink.trigger[1].overrun)
7-354
Model 2651A High Power System SourceMeter® Instrument Reference Manual
(on page 7-51)
(on page 7-52)
(on page 7-350)
(on page 7-351)
(on page 7-354)
(on page 7-355)
(on page 7-356)
(on page 7-357)
(on page 7-358)
Affected by
Instrument reset
TSP-Link trigger N clear
TSP-Link trigger N reset
Trigger overrun state
The trigger line (1 to 3)
Where saved Default value
Not applicable Not applicable
If an event was ignored, displays
true; if an event was not ignored,
displays false.
2651A-901-01 Rev. A / March 2011