Trigger.timer[N].Wait() - Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual
Trigger event IDs*
Event ID
smuX.trigger.PULSE_COMPLETE_EVENT_ID
smuX.trigger.SWEEP_COMPLETE_EVENT_ID
smuX.trigger.IDLE_EVENT_ID
digio.trigger[N].EVENT_ID
tsplink.trigger[N].EVENT_ID
lan.trigger[N].EVENT_ID
display.trigger.EVENT_ID
trigger.EVENT_ID
trigger.blender[N].EVENT_ID
trigger.timer[N].EVENT_ID
* Use the name of the trigger event ID to set the stimulus value rather than the numeric value. Using the name
makes the code compatible for future upgrades (for example, if the numeric values must change when
enhancements are added to the instrument).
Set this attribute to the eventID of any trigger event to wait for that event.
Use zero to disable event processing.
Example
print(trigger.timer[1].stimulus)
Also see
trigger.timer[N].reset()

trigger.timer[N].wait()

This function waits for a trigger.
Type TSP-Link accessible
Function Yes
Usage
triggered = trigger.timer[N].wait(timeout)
triggered
N
timeout
2651A-901-01 Rev. A / March 2011
(on page 7-343)
Affected by
Trigger detection indication
Trigger timer number (1 to 4)
Maximum amount of time in seconds to wait for the trigger
Event description
Occurs when the SMU completes a pulse
Occurs when the SMU completes a sweep
Occurs when the SMU returns to the idle state
Occurs when an edge is detected on a digital I/O line
Occurs when an edge is detected on a TSP-Link line
Occurs when the appropriate LXI trigger packet is
received on LAN trigger object N
Occurs when the TRIG key on the front panel is
pressed.
Occurs when a *TRG command is received on the
remote interface.
(GPIB only) Occurs when a GET bus command is
received.
(VXI-11 only) Occurs with the VXI-11 command
device_trigger. Reference the VXI-11 standard
for additional details on the device trigger operation.
Occurs after a collection of events is detected.
Occurs when a delay expires.
Prints the event that will start a trigger 1
timer action.
Where saved Default value
Section 7: Command reference
7-345