Lan.linktimeout - Keithley 2651A Reference Manual

Section 7: Command reference

lan.linktimeout

This attribute contains the LAN link timeout period.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
timeout = lan.linktimeout
lan.linktimeout = timeout
timeout
Details
You must enable the command lan.autoconnect before you can use this attribute.
The timeout value represents the amount of time that passes before the instrument disconnects from the LAN
due to the loss of the LAN link integrity.
The LAN interface does not disconnect if the connection to the LAN is reestablished before the timeout value
expires.
If the LAN link integrity is not restored before the timeout value expires, the instrument begins to monitor for a
new connection.
Example
print(lan.linktimeout)
Also see
lan.autoconnect
lan.restoredefaults()
7-112
Model 2651A High Power System SourceMeter® Instrument Reference Manual
Affected by
LAN restore defaults
The LAN link monitor time-out period (in seconds).
(on page 7-104)
(on page 7-114)
Where saved Default value
Nonvolatile memory 20
Outputs the present LAN link timeout setting.
2651A-901-01 Rev. A / March 2011