Status.operation.sweeping - Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual

status.operation.sweeping.*

This attribute contains the operation status sweeping summary register set.
Type TSP-Link accessible
Attribute - -
.condition (R) Yes
.enable (RW) Yes
.event (R) Yes
.ntr (RW) Yes
.ptr (RW) Yes
Usage
operationRegister = status.operation.sweeping.condition
operationRegister = status.operation.sweeping.enable
operationRegister = status.operation.sweeping.event
operationRegister = status.operation.sweeping.ntr
operationRegister = status.operation.sweeping.ptr
status.operation.sweeping.enable = operationRegister
status.operation.sweeping.ntr = operationRegister
status.operation.sweeping.ptr = operationRegister
operationRegister
Details
These attributes are used to read or write to the operation status sweeping summary registers. Reading a status
register returns a value. The binary equivalent of the returned value indicates which register bits are set. The
least significant bit of the binary number is Bit B0, and the most significant bit is Bit B15.
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to
2) and Enable and transition registers
meanings:
Bit Value
B0 Not used
B1
status.operation.sweeping.SMUA
B2-B5 Not used
In addition to the above constant, operationRegister can be set to the decimal equivalent of the bit to set.
Example
status.operation.sweeping.enable =
status.operation.sweeping.SMUA
Also see
Operation Status Registers
status.operation.*
2651A-901-01 Rev. A / March 2011
Affected by
- -
Not applicable
Status reset
Status reset
Status reset
Status reset
The operation status sweeping summary register's status. A zero (0) indicates no
bits set (also send 0 to clear all bits); the only valid value other than zero (0) is 2
(on page E-18). The individual bits of this register have the following
(on page E-20)
(on page 7-266)
Where saved Default value
- - - -
Not saved Not applicable
Not saved 0
Not saved 0
Not saved 0
Not saved 2 (All bits set)
Status register sets
Description
Not applicable.
Set bit indicates that SMU A is sweeping.
Bit B1 decimal value: 2
Binary value: 0000 0010
Not applicable.
Sets the SMUA bit of the operation
status sweeping summary enable
register using a constant.
Section 7: Command reference
(on page E-
7-295