Tspnet.tsp.abortonconnect; Tspnet.tsp.rbtablecopy() - Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual
Example
tspnet.tsp.abort(myConnection)
Also see
None

tspnet.tsp.abortonconnect

This attribute contains the setting for abort on connect.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
tspnet.tsp.abortonconnect = value
value = tspnet.tsp.abortonconnect
value
Details
This setting determines if the instrument sends an abort message when it attempts to connect to a TSP-enabled
instrument using the tspnet.connect() function.
When you send the abort command on an interface, it causes any other active interface on that instrument to
close. If you do not issue an abort command (or if tspnet.tsp.abortonconnect is set to 0) and another
interface is active, connecting to a TSP-enabled remote instrument results in a connection. However, the
instrument will not respond to subsequent reads or executes because control of the instrument is not obtained
until an abort command has been issued. See
Example
tspnet.tsp.abortonconnect = 0
Also see
tspnet.connect()

tspnet.tsp.rbtablecopy()

This function copies a reading buffer synchronous table from a remote instrument.
Type TSP-Link accessible
Function Yes
2651A-901-01 Rev. A / March 2011
Affected by
Instrument reset
1 (enable) or 0 (disable)
(on page 7-361)
Affected by
Stops myConnection.
Where saved
Not saved
Communications interfaces
Configure the instrument so that it does not
send an abort command when connecting to
a TSP-enabled instrument.
Where saved
Section 7: Command reference
Default value
1 (enabled)
(on page 2-73).
Default value
7-369