Tspnet.timeout; Tspnet.tsp.abort() - Keithley 2651A Reference Manual

Section 7: Command reference
Also see
tspnet.connect()
tspnet.disconnect()

tspnet.timeout

This attribute sets the timeout value for the tspnet.connect(), tspnet.execute(), and tspnet.read()
commands.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
value = tspnet.timeout
tspnet.timeout = value
value
Details
This attribute sets the amount of time the tspnet.connect(), tspnet.execute(), and tspnet.read()
commands will wait for a response.
The time is specified in seconds. The timeout may be specified to millisecond resolution, but is only accurate to
the nearest 10 ms.
Example
tspnet.timeout = 2.0
Also see
tspnet.connect()
tspnet.execute()
tspnet.read()

tspnet.tsp.abort()

This function stops remote instrument execution.
Type TSP-Link accessible
Function Yes
Usage
tspnet.tsp.abort(connectionID)
connectionID
Details
Sends an abort command to the remote instrument.
7-368
Model 2651A High Power System SourceMeter® Instrument Reference Manual
(on page 7-361)
(on page 7-363)
Affected by
Instrument reset
The timeout duration in seconds (0.001 s to 30.000 s)
(on page 7-361)
(on page 7-363)
(on page 7-365)
Affected by
Integer value used as a handle for other tspnet commands
Where saved
Not saved
Sets the timeout duration to two seconds.
Where saved Default value
Default value
20.0
2651A-901-01 Rev. A / March 2011