Smux.trigger.source_Complete_Event_Id - Keithley 2651A Reference Manual

Section 7: Command reference
Trigger event IDs*
Event ID
trigger.EVENT_ID
trigger.blender[N].EVENT_ID
trigger.timer[N].EVENT_ID
* Use the name of the trigger event ID to set the stimulus value rather than the numeric value. Using the name
makes the code compatible for future upgrades (for example, if the numeric values must change when
enhancements are added to the instrument).
Example
smua.trigger.source.stimulus =
digio.trigger[2].EVENT_ID
Also see
Triggering (on page 3-32)

smuX.trigger.SOURCE_COMPLETE_EVENT_ID

This constant contains the source complete event number.
Type TSP-Link accessible
Constant Yes
Usage
eventID = smuX.trigger.SOURCE_COMPLETE_EVENT_ID
eventID
X
Details
Set the stimulus of any trigger event detector to the value of this constant to have it respond to source complete
events from this SMU.
Also see
Triggering (on page 3-32)
7-248
Model 2651A High Power System SourceMeter® Instrument Reference Manual
Affected by
The source action complete event number
Source-measure unit (SMU) channel (for example,
smua.trigger.SOURCE_COMPLETE_EVENT_ID applies to SMU channel A)
Event description
Occurs when a *TRG command is received on the
remote interface.
(GPIB only) Occurs when a GET bus command is
received.
(VXI-11 only) Occurs with the VXI-11 command
device_trigger. Reference the VXI-11 standard
for additional details on the device trigger operation.
Occurs after a collection of events is detected.
Occurs when a delay expires.
Configure SMU channel A to
start its source action when a
trigger event occurs on digital I/O
line 2.
Where saved Default value
2651A-901-01 Rev. A / March 2011