Localnode.prompts4882; Localnode.reset() - Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual
Also see
localnode.showerrors

localnode.prompts4882

localnode.prompts4882
This attribute enables and disables the generation of prompts for IEEE Std 488.2 common commands.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
prompting = localnode.prompts4882
localnode.prompts4882 = prompting
prompting
Details
When set to 1, the IEEE Std 488.2 common commands generate prompts if prompting is enabled with the
localnode.prompts attribute. If set to 1, limit the number of *trg commands sent to a running script to 50
regardless of the setting of the localnode.prompts attribute.
When set to 0, IEEE Std 488.2 common commands will not generate prompts. When using the *trg command
with a script that executes trigger.wait() repeatedly, set localnode.prompts4882 to 0 to avoid
problems associated with the command interface input queue filling.
This attribute resets to the default value each time the instrument power is cycled.
When using this command from a remote node, localnode should be replaced with the node reference, for
example node[5].prompts4882.
Example
localnode.prompts4882 = 0
Also see
localnode.prompts

localnode.reset()

This function resets the local node instrument.
Type TSP-Link accessible
Function Yes
Usage
localnode.reset()
2651A-901-01 Rev. A / March 2011
(on page 7-139)
(on page 7-137)
Affected by
Power cycle
IEEE Std 488.2 prompting mode
(on page 7-136)
Affected by
Where saved Default value
Not saved 1 (enabled)
Disables IEEE Std 488.2 common command prompting.
Where saved Default value
Section 7: Command reference
7-137