Keithley 2651A Reference Manual page 42

Section 2: General operation
The following table contains descriptions of the configuration menus, as well as cross-references to
related information. To select a menu, press the CONFIG key and then the front-panel key associated
with the desired menu (see the description column in the following table).
Press the EXIT (LOCAL) key to return to a previous menu.
Configuration
menu
SRC
MEAS
LIMIT
SPEED
REL
FILT
OUTPUT
TRIG
STORE
Setting values
Setting a value
There are two ways to adjust a value: the Navigation wheel method or Numeric entry method
(using the keypad). To use the keypad, the keypad feature must be enabled. When using either
method, use the following editing techniques:
To set a value to zero, press the 0000 numeric entry key. To toggle the polarity of a value, press the
+/– numeric entry key.
2-20
Model 2651A High Power System SourceMeter® Instrument Reference Manual
To access, press Description
the CONFIG key
and then:
SRC V-source sense, low range;
I-source low range; and highC
mode
MEAS V and I-measure sense, low
range; autozero
LIMIT V-source and I-source
compliance limits
SPEED Measurement speed (NPLC)
REL Set relative values
FILTER Control digital filter
OUTPUT ON/OFF Set off-state, control digital I/O
TRIG Set trigger in, count, interval,
and delay
STORE Set buffer count and
destination
Quick Tip
For more information, see:
Range (on page 2-65)
Range (on page 2-65)
Compliance limit
Speed (on page 2-71)
Rel (on page 3-1)
Filters (on page 3-3)
Output-off states
Triggering (on page 3-32)
Source-measure concepts
2)
Quick Tip
(on page 2-12)
(on page 2-59)
(on page 4-
2651A-901-01 Rev. A / March 2011