Model 2651A High Power System SourceMeter® Instrument Reference Manual
2. At the command prompt, type ipconfig/all and press the Enter key. A list of existing IP
configuration information for your computer is displayed.
If the information for the Ethernet adapter displays "Media Disconnected," close the command prompt
and go to
Step 2: Disable DHCP to use the computer's existing IP address
3. When the information is displayed, record the following information for the correct network card:
•
DHCP mode: _______________________________
•
IP address: ________________________________
•
Subnet mask: ______________________________
•
Default gateway: ____________________________
•
DNS servers: _______________________________
The ipconfig/all command displays the configuration of every network card. Make sure that you
record the information for the proper network card.
2651A-901-01 Rev. A / March 2011
Figure 120: Computer IP configuration using the command prompt
Appendix C: LAN concepts and settings
Network card
NOTE
CAUTION
DHCP Enabled:
No
IP Address
Subnet Mask
255.255.255.0
(on page C-4).
C-3