Lan.config.duplex; Lan.config.gateway - Keithley 2651A Reference Manual

Section 7: Command reference
Details
When this is enabled, the instrument performs DNS lookups to verify that the DNS host name matches the value
specified by lan.config.dns.hostname.
Example
print(lan.config.dns.verify)
Also see
lan.config.dns.hostname
lan.restoredefaults()

lan.config.duplex

This attribute defines the LAN duplex mode.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
duplex = lan.config.duplex
lan.config.duplex = duplex
duplex
Details
This attribute does not indicate the actual setting currently in effect. Use the lan.status.duplex attribute to
determine the current operating state of the LAN.
Also see
lan.restoredefaults()

lan.config.gateway

This attribute contains the LAN default gateway address.
Type TSP-Link accessible
Attribute (RW) Yes
7-108
Model 2651A High Power System SourceMeter® Instrument Reference Manual
(on page 7-107)
(on page 7-114)
Affected by
LAN restore defaults
LAN duplex setting can be one of the following values:
1 or lan.FULL: Selects full-duplex operation
0 or lan.HALF: Selects half-duplex operation
(on page 7-114)
Affected by
LAN restore defaults
Outputs the present DNS host name verification
state.
If it is enabled, the output is:
1.00000e+00
Where saved Default value
Nonvolatile memory lan.FULL
Where saved Default value
Nonvolatile memory "0.0.0.0"
2651A-901-01 Rev. A / March 2011