Keithley 2651A Reference Manual page 688

Model 2651A High Power System SourceMeter® Instrument Reference Manual
Error summary
Error number
2408
2409
2410
2411
2412
2413
2414
2415
2416
2417
4900
4901
4903
4904
4905
4906
5001
5003
5004
5005
5007
5008
5009
5010
5011
5012
5013
5014
5015
5016
5017
5018
5019
5021
5022
5023
5024
5025
5027
5028
5029
5032
5033
5038
5040
5041
5042
5043
2651A-901-01 Rev. A / March 2011
Error level Error Message
RECOVERABLE TSPnet write failure, aborted
RECOVERABLE TSPnet write failure, timeout
RECOVERABLE TSPnet max connections reached
RECOVERABLE TSPnet connection failed
RECOVERABLE TSPnet invalid termination
RECOVERABLE TSPnet invalid reading buffer table
RECOVERABLE TSPnet invalid reading buffer index range
RECOVERABLE TSPnet feature only supported on TSP connections
RECOVERABLE TSPnet musty specify both port and init
RECOVERABLE TSPnet disconnected by other side
RECOVERABLE Reading buffer index %s is invalid
RECOVERABLE The maximum index for this buffer is %d
RECOVERABLE Reading buffer expired
SERIOUS ICX parameter count mismatch, %s (Line #%d)
SERIOUS ICX parameter invalid value, %s (Line #%d)
SERIOUS ICX invalid function id, %s (Line #%d)
FATAL SMU is unresponsive
SERIOUS Saved calibration constants corrupted
SERIOUS Operation conflicts with CALA sense mode
SERIOUS Value too big for range
SERIOUS Operation would exceed safe operating area of the instrument
SERIOUS Operation not permitted while output is on
SERIOUS Unknown sourcing function
SERIOUS No such SMU function
SERIOUS Operation not permitted while cal is locked
SERIOUS Cal data not saved - save or restore before lock
SERIOUS Cannot save cal data - unlock before save
SERIOUS Cannot restore cal data - unlock before restore
SERIOUS Save to cal set disallowed
SERIOUS Cannot change cal date - unlock before operation
SERIOUS Cannot change cal constants - unlock before operation
SERIOUS Cal version inconsistency
SERIOUS Cannot unlock - invalid password
SERIOUS Cannot restore default calset. Using previous calset
SERIOUS Cannot restore previous calset. Using factory calset
SERIOUS Cannot restore factory calset. Using nominal calset
SERIOUS Cannot restore nominal calset. Using firmware defaults
SERIOUS Cannot set filter.count > 1 when measure.count > 1
SERIOUS Unlock cal data with factory password
SERIOUS Cannot perform requested operation while source autorange is
enabled
SERIOUS Cannot save without changing cal date and cal due values
RECOVERABLE Cannot change this setting unless buffer is cleared
RECOVERABLE Reading buffer not found within device
RECOVERABLE Index exceeds maximum reading
RECOVERABLE Cannot use same reading buffer for multiple overlapped
measurements
SERIOUS Output Enable not asserted
SERIOUS Invalid while overlapped measure
SERIOUS Cannot perform requested operation while voltage measure
autorange is enabled
Section 8: Troubleshooting guide
8-5