Lan.status.dns.address[N] - Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual
Details
The settings that are restored are shown in the following table.
Settings that are restored to default
Attribute
lan.autoconnect
lan.config.dns.address[N]
lan.config.dns.domain
lan.config.dns.dynamic
lan.config.dns.hostname
lan.config.dns.verify
lan.config.duplex
lan.config.gateway
lan.config.ipaddress
lan.config.method
lan.config.speed
lan.config.subnetmask
lan.linktimeout
lan.lxidomain
lan.nagle
lan.timedwait
The lan.restoredefaults() function does not reset the LAN password. The localnode.password
attribute controls the web password, which can be reset separately.
This command is run when lan.reset() is sent.
Example
lan.restoredefaults()
Also see
lan.reset() (on page 7-114)
localnode.password

lan.status.dns.address[N]

This attribute contains the DNS server IP addresses.
Type TSP-Link accessible
Attribute (R) Yes
Usage
dnsAddress = lan.status.dns.address[N]
dnsAddress
N
2651A-901-01 Rev. A / March 2011
Default setting
lan.ENABLE
"0.0.0.0"
""
lan.ENABLE
""
lan.ENABLE
lan.FULL
"0.0.0.0"
"192.168.0.2"
lan.AUTO
100
"255.255.255.0"
20 (seconds)
0
lan.ENABLE
20 (seconds)
(on page 7-134)
Affected by
Not applicable
DNS server IP address
Entry index (1, 2, or 3)
Restores the LAN defaults.
Where saved Default value
Not applicable Not applicable
Section 7: Command reference
7-115