Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Figure 7-14 Installing a VCN500
Step 5 Reconnect the cables to the new VCN500.
Step 6 Turn on the power switch of the VCN500.
Step 7 Commissioning the VCN500. If the video recording function works properly after
commissioning, the VCN500 is functional.
----End
7.2.6.2 Replacing the Hard Disk
Prerequisites
Context
Recommended tools and materials: Phillips screwdriver, ESD wrist strap (or ESD gloves).
Procedure
Step 1 Put on an ESD wrist strap (or ESD gloves) and insert the ground terminal into the ESD jack in
the cabinet.
Step 2 Remove the faulty hard disk.
1.
2.
3.
Issue 03 (2019-03-10)
The hard disk needs to be replaced.
Data in the hard disk has been backed up.
A spare hard disk of the same model is available and functional.
Press the button on the hard disk panel to open the ejector lever.
Pull out the hard disk for about 3 cm, wait for 30 seconds at least until the hard disk
stops rotating, and pull it out.
Use a screwdriver to loosen the screws from the hard disk and remove the hard disk.
Copyright © Huawei Technologies Co., Ltd.
7 Device Maintenance
275
Advertisement
Table of Contents
