Installing The Hydrogen Detection System - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Figure 3-11 Installing a temperature sensor
----End

3.6.2 Installing the Hydrogen Detection System

Context


Procedure
Step 1 Install four expansion bolts (M6x60) to the specified positions, align the four mounting ears
of the hydrogen detection system with the expansion bolts, and tighten the M6 nuts.
Issue 03 (2019-03-10)
The hydrogen detection system is used to detect the hydrogen density indoors. When the
hydrogen density exceeds the alarm threshold, the system generates alarms.
The hydrogen detection system is installed on the interior wall of the area to be detected.
Copyright © Huawei Technologies Co., Ltd.
3 Installing Devices
22