Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Procedure
Step 1 Modify the IP address for the VCN500.
1.
2.
3.
4.
Step 2 Enabling camera NTP synchronization.
The camera NTP synchronization function for the server is disabled by default. The camera
NTP synchronization function needs to be enabled for the server that connects to cameras.
After the camera NTP synchronization function is enabled, cameras will automatically
time-synchronize from their access servers.
1.
2.
3.
Issue 03 (2019-03-10)
Configure the PC IP address and the VCN500 IP address in the same network segment.
Enter the OMU Portal address (https://192.168.1.100:8443 by default) in the address bar
of the Internet Explorer and press Enter button.
You can log in to the OMU portal using only Windows Internet Explorer 8.0 or later.
On the login page, enter the user name Admin and preset password Change_Me, and
click Log In to enter the OMU Portal page. A message is displayed upon the first login
indicating that you should modify the password. After modifying the password, keep it
properly.
Choose Local Configuration > Server configuration, and set the service IP address
(VCN500 IP address) and NAT IP address according to the site requirements.
Figure 6-16 Configuring the server
Set Business IP to XXX.XXX.XXX.XXX, Subnet mask to XXX.XXX.XXX.XXX, Gateway IP to
XXX.XXX.XXX.XXX. The values here are examples. The actual values prevail.
Set NAT IP to VCN500 external IP address.
Configure the NTP synchronization. After setting The NTP clock source server to Yes,
set the IP address of the NTP server.
The server that connects to cameras needs to enable the camera NTP synchronization function.
Log in to the OMU portal of the VCN as the Admin user.
Choose Maintenance > Unified Configuration.
Select the server that the camera needs to access, set Module name to SCU and
Parameter type to System property, and click Search.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
142
Advertisement
Table of Contents
