Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Figure 3-62 Removing an emergency door release button
1.
2.
3.
Step 2 Mark the mounting holes using a marker and the base.
Figure 3-63 Marking mounting holes (unit: mm)
Step 3 Drill holes using a hammer drill, and route cables out of the cable hole.
Step 4 Install the emergency door release button.
Issue 03 (2019-03-10)
Remove screws from the emergency door release button using a Phillips screwdriver, as
shown by (1) in
Figure
Remove the glass panel of the emergency door release button, as shown by (2) and (3) in
Figure
3-62.
Remove screws from the base, and remove the base, as shown by (4) in
Copyright © Huawei Technologies Co., Ltd.
3-62.
3 Installing Devices
Figure
3-62.
57
Advertisement
Table of Contents
