Setting Ups5000 Monitoring Parameters (Over Snmp) - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
8.
9.
----End

6.3.4.2 Setting UPS5000 Monitoring Parameters (over SNMP)

Prerequisites


Context



Issue 03 (2019-03-10)
Figure 6-32 Setting SNMP parameters_04
Input the NetEco server IP address in NMS addr, set Permission to Write, write 162 in
Trap port, click Add.
Figure 6-33 Setting SNMP parameters_05
Click Submit.
You have obtained the IP address, subnet mask, and default gateway planned for the
UPS5000.
The UPS5000 is powered on.
Before connecting the UPS5000 to the NetEco, set the IP address on the UPS5000, and
add a user and set rights on the UPS5000 WebUI.
UPS WebUIs may vary slightly depending on the UPS software version. Perform
operations based on the actual WebUI.
The non-encryption algorithm used in UPS5000 poses potential risks. Therefore,
exercise caution when deciding to use the non-encryption algorithm.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
164