Installing A Hot-Swap Hard Disk Drive; Figure 2-20 Install A Hot-Swap Power Supply - Huawei Tecal RH5485 Installation And User Manual

Hide thumbs Also See for Tecal RH5485:

Table of Contents

2 Installing optional devices

To install an additional hot-swap power supply, complete the following steps:

1. Read t h e Tecal RH5485 Safety Information .

2. Press the blue release latch on the power-supply filler and pull the handle to the open

position. Then, remove the filler from power-supply bay 2.

3. If the handle is not already in the open position, press the orange release latch on the

power-supply handle to the right and lift the handle up to the open position.

4. Slide the power supply into the bay and fully close the locking handle by sliding it down

to the locked position.

5. Connect one end of the power cord for the new power supply into the ac connector on the

back of the power supply, and connect the other end of the power cord into a properly

grounded electrical outlet.

6. Make sure that the ac power LED on the power supply is lit, indicating that the power

supply is operating correctly. If the server is turned on, make sure that the dc power LED on

the top of the power supply is lit also.

2.11 Installing a hot-swap hard disk drive

The following notes describe the types of hard disk drives that the server supports and other

information that you must consider when you install a hard disk drive:



2-26

The server supports up to eight 1-inch (26 mm) slim-high, 2.5-inch, hot-swap hard disk

drives in the standard hot-swap bays.

Huawei Proprietary and Confidential

Tecal RH5485 Server

Installation and User's Guide

Issue 02 (2011-05-25)

Table of Contents