Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Parameter
Write Community
Timeout period
Table 6-21 SNMP v3 device parameter description
Parameter
Name
IP Address
Port
Security Name
Authentication
Protocol
Authentication
Password
Privacy Protocol
Privacy Password
Timeout period
Step 7 Click Connection Test to start the connection test.
Step 8 After the connection test is successful, click
information.
----End
Issue 03 (2019-03-10)
Description
Set this parameter to the write community set on the device. (set to
private by default)
Modifying community per three months is advised.
Timeout duration for connection test (set to 3s by default)
Description
Device name
Set this parameter to the device IP address.
Set this parameter to the port number of the device. (set to 161 by
default)
Set this parameter to the user name added in SNMPv3 on the
WebUI of the device.
Set this parameter to the authentication protocol set on the device.
The default selection is SHA.
Support SHA and MD5 agreement.
Set this parameter to the SHA or MD5 password set on the device.
Set this parameter to the privacy protocol set on the device. The
default selection is AES.
Support CBC_DES, AES128, AES192, and AES256 agreement.
Set this parameter to the AES or DES password set on the device.
NOTE
You are advised to set Authentication Password and Privacy Password to
different values.
Timeout duration for connection test (set to 3s by default)
Copyright © Huawei Technologies Co., Ltd.
in the toolbar to save the device
6 Adding Devices
181
Advertisement
Table of Contents
