Connecting The Ups5000-E Or Ups5000-S Monitoring Cable; Connecting The Pdu8000 Monitoring Cable; Connecting A Monitoring Cable To Tp483000D - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
----End

4.2.5.3 Connecting the UPS5000-E or UPS5000-S Monitoring Cable

Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of a network cable to the FE port on the UPS5000-E/UPS5000-S monitoring
module.
Step 2 Connect the other end of the network cable to the Ethernet port on the LAN switch.
----End

4.2.6 Connecting the PDU8000 Monitoring Cable

Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of the network cable to the FE port in the display panel of PDU8000, as
shown in
Figure 4-25 Connecting the PDU8000 monitoring cable (FE port)
(1) FE port
Step 2 Connect the other end of the network cable to the Ethernet port on the LAN switch.
----End

4.2.7 Connecting a Monitoring Cable to TP483000D

Prerequisites
A network cable used for monitoring is prepared.
Issue 03 (2019-03-10)
Figure 4-25.
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
78