Replacing The Independent Deployment Ai/Di Unit - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
8.
9.
10. Connect the communications cable, WiFi module, and antenna to the ECC800 main
11. Use the default user name and password to log in to the ECC WebUI.
12. (Optional) Choose System Settings > SNMP Settings, and fill out the recorded
13. (Optional) Choose System Settings > Monitor Module IP to fill out the recorded IP
14. Import the backup configuration file or set parameters for the devices that connect to the
15. Delete the old ECC800 collector on the NetEco. Create a newly-connected ECC800

7.2.4 Replacing the independent deployment AI/DI unit

Prerequisites


Context
Recommended tools and materials: Phillips screwdriver
Procedure
Step 1 Disconnect power supply from the independent deployment AI/DI unit. Then, remove cables
that connect the independent deployment AI/DI unit, label the cables, and record where the
labeled cables were connected.
Issue 03 (2019-03-10)
Install the removed Micro SD and SIM card in the corresponding slot of the new
ECC800 main control module.
Figure 7-4 Installing the Micro SD and SIM cards
Install the spare ECC800 main control module in the ECC800 subrack and tighten the
screws on both sides of the ECC800 main control module.
control module.
information about areas SNMPv3 and SNMP Trap.
address.
ECC800 to ensure normal communication.
collector.
The independent deployment AI/DI unit needs to be replaced.
A spare independent deployment AI/DI unit of the same model is available and
functional.
Copyright © Huawei Technologies Co., Ltd.
7 Device Maintenance
264