Adding Temperature Sensors; Setting Temperature Sensor Monitoring Parameters - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Procedure
Step 1 Choose Configuration > Configuration Management > Data Center Planning from the
main menu. The Data Center Planning window is displayed.
Step 2 Click
Step 3 In the navigation pane on the left, select a device.
Step 4 Click the Counter tab and modify performance counter names.
Step 5 Click Apply.
----End

6.4.2.2 Adding Temperature Sensors

6.4.2.2.1 Setting Temperature Sensor Monitoring Parameters

After connecting a temperature sensor to the AI/DI port on the independent deployment AI/DI
unit of an ECC500 V6 collector, you need to set temperature sensor monitoring parameters on
the web user interface (WebUI) of the collector.
Prerequisites


Context


Procedure
Step 1 Log in to the WebUI of the ECC500 V6 collector.
Step 2 Choose Monitoring > MUE06A1 > Running Parameters > AI/DI_1 Port Settings.
Step 3 Select Enable for AI/DI_1 Sensor.
Issue 03 (2019-03-10)
in the toolbar to access Counter Rename.
You have obtained the IP address, and login user name and password for the ECC500 V6
collector.
A PC with an IP address in the same network segment as the ECC500 V6 collector is
prepared, and the PC has been connected to the ECC500 V6 collector over a switch.
Perform operations described in this section only when the independent deployment
AI/DI unit of the NTC sensor is connected to the communications cards in slot 3 or 4 of
the ECC500 collector.
Temperature sensors can be automatically identified and do not need manual setting.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
208