Replacing A Fingerprint And Card Reader With A Keypad - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Figure 7-36 Removing a bottom plate
Step 2 Remove the original bottom plate, as shown by (4) in
Step 3 Take out the bottom plate of the new card reader with a keypad and secure it.
Step 4 Connect the cable.
Step 5 Secure the card reader with a keypad to the bottom plate.
Step 6 Choose System > Configuration Management > Data Center Planning from the main
menu. The Data Center Planning window is displayed.
Step 7 Select the new card reader with a keypad, and click Connection Test. When Connection
success is displayed, the replacement is complete.
----End

7.2.7.7 Replacing a Fingerprint and Card Reader with a Keypad

Prerequisites



Issue 03 (2019-03-10)
Recommended tool: Phillips screwdriver
A fingerprint and card reader with a keypad needs to be replaced.
A spare fingerprint and card reader with a keypad of the same model is available and
functional.
Copyright © Huawei Technologies Co., Ltd.
7 Device Maintenance
Figure 7-36.
291