Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Step 5 Route the magnetic lock cable through the cable hole, and secure the magnetic lock using a
hex key, as shown by (2) in
Step 6 Install the magnet.
1.
2.
Figure 3-49 Installing the magnet
(1) Rubber pad
Issue 03 (2019-03-10)
Take out the magnet, and knock the positing pins of the magnet into the magnet using a
rubber mallet.
Figure 3-48 Installing positioning pins of a magnet
Insert the assembled magnet into the positioning holes in the door, and secure the magnet
to the door using the screws and rubber pad delivered with the magnetic lock, as shown
in
Figure
3-49.
When securing the magnet to the door panel, do not over-tighten the screws so that the rubber pad is
elastic. The rubber pad will adjust the magnet to a correct position because of its elasticity.
Copyright © Huawei Technologies Co., Ltd.
Figure
3-47.
3 Installing Devices
47
Advertisement
Table of Contents
