Installing A Fingerprint And Card Reader - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Step 5 Check that cables are correctly connected.
Step 6 Secure the fingerprint and card reader with a keypad to the baseplate, as shown by (5) and (6)
in
Figure 3-57 Installing a fingerprint and card reader with a keypad
----End

3.8.5 Installing a Fingerprint and Card Reader

Context


Procedure
Step 1 Remove the screws (set aside) from the fingerprint and card reader and remove the baseplate,
as shown by (1) in
Step 2 Mark the mounting holes using a marker, and drill holes using a hammer drill.
Issue 03 (2019-03-10)
Figure 3-57.
It is recommended that the product be installed 30–300 mm close to the equipment room
door and 1.4–1.6 m above the floor.
Do not install the product in a place with heavy dust or exposed to sunlight.
Figure
Copyright © Huawei Technologies Co., Ltd.
3-59.
3 Installing Devices
53