Scenarios For Connecting The Ecc800 Collector; Commissioning Southbound Devices Of Ecc800; Setting And Adding The Ecc800 Collector; Setting Neteco Parameters - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Step 8 After the connection test is successful, click
information.
----End

6.5 Scenarios for Connecting the ECC800 Collector

6.5.1 Commissioning Southbound Devices of ECC800

For details, see commissioning chapter in ECC800 Data Center Controller User Manual.

6.5.2 Setting and Adding the ECC800 Collector

The requirements for ECC800 WebUI login are as follows.
Computer operating system: Windows 7 and later versions
Browser: IE9 and later versions; Firefox and later versions; Chrome and later versions

6.5.2.1 Setting NetEco Parameters

When the smart module can be connected to the NetEco, perform the following steps to
configure parameters.
Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Step 2 Set the IP address, subnet mask, and default gateway on the ECC800 WebUI.
Table 6-45 IP parameters
Path
System
Settings >
System
Parameters
> Monitor
Module
IP >
WAN_1
Step 3 Set NetEco communications parameters on the ECC800 WebUI.
Table 6-46 NetEco parameters
Path
Issue 03 (2019-03-10)
Parameter Default
Value
IP 192.168.1.10
Subnet mask 255.255.255.
0
Default 192.168.1.1
gateway
Parameter Default
Value
Copyright © Huawei Technologies Co., Ltd.
in the toolbar to save the device
Setting Value
Set this parameter based on the IP address
assigned by the network administrator.
Set this parameter based on the subnet mask
assigned by the network administrator.
Set this parameter based on the default
gateway address assigned by the network
administrator.
Setting Value
6 Adding Devices
242