Replacing The Hard Disk - Huawei FusionModule5000 Maintenance Manual

FusionModule2000 Smart Modular Data Center
Maintenance Guide
Figure 5-5 Removing an RS485 card
Step 5 Hold the handle of a new module, and place the module into the correct slot in the ECC500
subrack.
Step 6 Push the new module into the subrack until their front panels are aligned with each other.
Step 7 Close the handle.
Step 8 Use an M3 Phillips screwdriver to tighten the two captive screws on the new module panel
clockwise.
Step 9 Reconnect the cables to the new module based on the labels.
Step 10 Reconnect the ECC power supply.
----End

5.4.4 Replacing the Hard Disk

Prerequisites



Context
Recommended tools and materials: Phillips screwdriver, ESD wrist strap (or ESD gloves)
Procedure
Step 1 Put on an ESD wrist strap (or ESD gloves) and insert the ground terminal into the ESD jack in
the cabinet.
Step 2 Remove the faulty hard disk.
1.
2.
3.
Issue 01 (2016-10-18)
The hard disk needs to be replaced.
Data in the hard disk has been backed up.
A spare hard disk of the same model is available and functional.
Press the button on the hard disk panel to open the ejector lever, as shown by (1) in
Figure 5-6.
Pull out the hard disk for about 3 cm, wait for 30 seconds at least until the hard disk
stops rotating, and pull it out, as shown by (2) in
Use a screwdriver to loosen the screws from the hard disk and remove the hard disk, as
shown by (3) and (4) in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-6.
5 Parts Replacement
Figure 5-6.
39