Huawei iManager NetEco 6000 Device Installation And Commissioning Manual page 103

iManager NetEco 6000
Device Installation and Commissioning Guide
Table 4-12 Cable connections for the fingerprint and card reader with a keypad
Conversion Cable
Red wire
Green wire
White wire
Black wire

Table 4-13 Pin mapping for the RS485 port and the COM port
RS485 Port on Fingerprint and Card Reader with a
Keypad
Pins
Pin1
Pin2
Connecting Cables to the Card Reader with a Keypad
The following figure shows the cable connections to the access controller and card reader
with a keypad, using the cord end terminal to crimp the cable.
Figure 4-35 Connecting cables to the card reader with a keypad
Issue 03 (2019-03-10)
Connect one end of another network cable to the RS485 port on the fingerprint and card
reader with a keypad, and connect the other end of the network cable to the
non-energized COM port on the ECC500 collector. The following table shows the pin
mapping for the RS485 port and the COM port.
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
Wire of the Network
Cable
Pin3
Pin4
Pin5
Pin8
Definition
485A (brown)
485B (white)
Access Controller
Terminal
R-12V
R-D0
R-D1
R-GND
COM Port on ECC500
Collector
Pins
Pin1
Pin2
92