Imanager Neteco - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000

Device Installation and Commissioning Guide
Connecting Cables to the Exit Button
Figure 4-33
cord end terminal to crimp the cable.
Figure 4-33 Connecting cables to the exit button
Connecting Cables to the Fingerprint and Card Reader with a Keypad
The following figure shows the cable connections to the access controller and fingerprint and
card reader with a keypad, using the cord end terminal to crimp the cable.
Figure 4-34 Connecting cables to the fingerprint and card reader with a keypad

Issue 03 (2019-03-10)
shows the cable connections to the access controller and exit button, using the
Connect one end of the network cable to the female connector of the fingerprint and card
reader with a keypad. Strip the other end of the network cable and connect it to the
access controller terminal, as shown in the preceding figure.
If the network is non-standard, connect it by referring to the cable sequence in the following table.
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
91