Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Figure 6-27 Adding a camera using automatic discovery
----End
Follow-up Procedure
Table 6-9
Table 6-9 Follow-up procedure
If You Want To...
Query the information about a camera
Refresh the camera list
Issue 03 (2019-03-10)
The method of adding a camera using automatic discovery applies to all other management domains
except Subnet and Root.
After a camera is added, it will be displayed under the corresponding management domain on the
Data Center Planning page. On the Data Center Planning page, you can set parameters such as
the Name for the camera.
describes the operations that can be performed on the Discovery Camera page.
Copyright © Huawei Technologies Co., Ltd.
Then...
1. On the Discovery Camera page, specify
one or multiple of the keywords Code,
Name, and IP Address.
2. Click Search.
To reset the search criteria, click Reset.
On the Discovery Camera page, click
Refresh. The camera information in the list
is refreshed.
6 Adding Devices
156
Advertisement
Table of Contents
