Huawei iManager NetEco 6000 Device Installation And Commissioning Manual page 282

iManager NetEco 6000
Device Installation and Commissioning Guide
Figure 7-10 Water sensor components
(1) Water sensor
(4) Conversion cable end B,
connecting to water the
detection cable
Recommended tool and material: crimping tool
Procedure
Step 1 Replace the water sensor.
1.
2.
3.
Issue 03 (2019-03-10)
Remove the conversion cable at the conversion port for the water sensor and conversion
cable.
Connect a new water sensor to the conversion cable, as shown in
Secure the new water sensor.
Copyright © Huawei Technologies Co., Ltd.
(2) Conversion cable end A,
connecting to the water detector
(5) Water detection cable end A,
connecting to the conversion
cable
7 Device Maintenance
(3) Conversion cable
(6) Water detection
cable
Figure 7-11.
271