Setting Pass-Through Parameters For The Ecc500 V6 Collector - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
----End

6.4.1.2 Setting Pass-through Parameters for the ECC500 V6 Collector

You need to set the pass-through parameters for the ECC500 V6 collector if it connects to the
EMS, as these parameters are needed for setting up the challenge handshake authentication on
the EMS.
Prerequisites


Procedure
Step 1 Log in to the WebUI of the ECC500 V6 collector.
Step 2 Choose System Settings > Pass-through Settings.
Step 3 Set Enable security authentication parameters.


Step 4 (Optional) Replace the security certificate for network elements to connect to the NetEco.
1.
Issue 03 (2019-03-10)
You have obtained the IP address, and login user name and password for the ECC500 V6
collector.
A PC with an IP address in the same network segment as the ECC500 V6 collector is
prepared, and the PC has been connected to the ECC500 V6 collector over a switch.
If the version of ECC is ECC500 V600R001C01 or earlier, set Enable security
authentication to Disable. Click Submit and click OK in the displayed dialog box.
If the version of ECC is later than ECC500 V600R001C01, perform the following
operations.
− Set Enable security authentication to Enable. Click Submit and click OK in the
displayed dialog box.
− In Challenge certification password, click Reset Password. In the displayed
dialog box, click OK to restore the preset password .3N:{Se7q4152H5X.
Alternatively, in Challenge certification password, set New Password and
Confirm password and then click Change password.
Keep in mind the password that is set in Challenge certification password. The password will be used
for transparent transmission settings on the NetEco.
 The NetEco system provides a Huawei-preinstalled default certificate for commissioning the
connections between network elements and the NetEco. The default certificate cannot ensure
information transmission security, and must be replaced by a valid certificate from Huawei if the
secure communication mode is to be enabled.
 The security certificate for the ECC500 collector to connect to the NMS can be replaced only when
the Enable security authentication parameter is set to Enable for the ECC500 collector.
Replace the security certificate of the ECC500 collector: On the ECC500 WebUI, choose
System Settings > Pass-through Settings, click Browse... to enter the path where the
certificate is stored, select the certificate, and click Upload. After the upload is complete,
click Submit.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
184