Replacing A Location-Type Water Sensor And Water Detection Cable - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Figure 7-11 Connecting a conversion cable to a water sensor
Step 2 Replace a water detection cable.
1.
2.
Figure 7-12 Connecting a new water detection cable
(1) Conversion cable end B, connecting to
the water detection cable
----End
Follow-up Procedure
Check whether the new water sensor works properly. Connect the network cable between the
water detector and ECC, immerse the water detection cable in water, and check whether an
alarm is generated. If an alarm is generated, the replacement is complete.

7.2.5.7 Replacing a Location-type Water Sensor and Water Detection Cable

Prerequisites


Issue 03 (2019-03-10)
Remove the faulty water detection cable from the port.
Install a new water detection cable, as shown in
The water detection cable and conversion cable are interconnected through the male and female
connectors.
The water sensor needs to be replaced.
A spare water sensor of the same model is available and functional.
Copyright © Huawei Technologies Co., Ltd.
Figure 7-12.
(2) Water detection cable end A, connecting
to the conversion cable
7 Device Maintenance
272