Creating A Rpdu On The Neteco - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Step 2 Enter monitoring parameters of the PDU2000. For the input method, see
parameters not mentioned in the table, retain the default value.
Table 6-19 Remarks
Parameter
IP address
Subnet mask
Gateway
Address reporting the SNMP
----End

6.3.7.2 Creating a RPDU on the NetEco

Prerequisites



Procedure
Step 1 Choose Configuration > Configuration Management > Data Center Planning from the
main menu. The Data Center Planning window is displayed.
Step 2 Select the management domain to add a device.
Step 3 If the management domain is a rack or a DDF, click the management domain and choose
Design under
Step 4 In the lower-left corner of the page, click the drop-down list box in Type and select RPDU.
Step 5 Select the device to be added and drag its icon to the management domain.
Step 6 Specify parameters shown in
RPDU complying with the SNMP protocol is used as an example.
Issue 03 (2019-03-10)
You have logged in to the NetEco client.
You have the operation rights for Data Center Planning.
You have created a management domain for the device to be added on the Data Center
Planning page.
. The page for adding a device is displayed. Otherwise, skip this step.
To delete a device, click the device and choose Delete under
Copyright © Huawei Technologies Co., Ltd.
Setting Method
Enter the planned PDU2000 IP address.
Enter the planned PDU2000 subnet mask.
Enter the planned PDU2000 gateway.
Enter the IP address of the NetEco the
PDU2000 connects to.
Figure 6-41 in the right pane based on the following table. The
6 Adding Devices
Table 6-19. For
.
179