Creating An Electronic Door Lock On The Neteco - Huawei iManager NetEco 6000 Device Installation And Commissioning Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
Step 7 Click Connection Test to start the connection test.
Step 8 After the connection test is successful, click
information.
Step 9 Click Bind AccessController and select an access controller to bind the fingerprint controller
and select a door passage for the access controller from respective drop-down menus.
----End

6.4.3.7 Creating an Electronic Door Lock on the NetEco

Prerequisites



Procedure
Step 1 Choose Configuration > Configuration Management > Data Center Planning from the
main menu. The Data Center Planning window is displayed.
Step 2 Select the management domain to add a device.
Step 3 In the lower-left corner of the page, click the Device tab.
Step 4 Click the drop-down list box in Type and select Access Controller.
Step 5 Select the device to be added and drag its icon to the management domain.
Step 6 Specify parameters shown in
Issue 03 (2019-03-10)
You have logged in to the NetEco client.
You have the operation rights for Data Center Planning.
You have created a management domain for the device to be added on the Data Center
Planning page.
An electronic door lock must be created in a cabinet.
To delete a device, click the device and choose Delete under
Copyright © Huawei Technologies Co., Ltd.
in the toolbar to save the device
Figure 6-79 in the right pane based on the following table.
6 Adding Devices
.
228