Table of Contents
Advertisement
iManager NetEco 6000
Device Installation and Commissioning Guide
Figure 3-15 Installing a smoke detector
Step 3 Align the mounting holes in the smoke detector with its base, and then rotate the smoke
detector until it is secured.
----End
3.6.4 Installing an Infrared Sensor
Prerequisites
An infrared sensor and tools for installing it have been prepared.
Context
Procedure
Step 1 Take out the infrared sensor base and mark mounting holes for the base in the appropriate
area.
Step 2 Drill holes and install expansion sleeves as shown in
Issue 03 (2019-03-10)
The infrared sensor is used to monitor personnel's entry into and exit from the equipment
room.
The infrared sensor should be installed on the interior wall of the area to be monitored.
Copyright © Huawei Technologies Co., Ltd.
3 Installing Devices
Figure
3-16.
25
Advertisement
Table of Contents
